Effectiveness of using a Dremel Tool to cut steel?

by **gvblake22** » Thu Jul 21, 2005 12:20 pm

Ok, when I cut my side panel I used a jigsaw with a fine toothed blade and it kinda ripped up and bent the edges where it cut. The material is 0.8mm SECC Steel and I am wondering what (if any) cutting attachment for a Dremel tool would effectively cut this steel?

If not a Dremel, what would you recommend?

by **infinitevalence** » Thu Jul 21, 2005 12:33 pm

Dremel is the way to go get the fiberglass reinforced cutting wheels. Tape off your design and take your time! but it works. If you have a decent jigsaw with a very good blade then its not so bad, but your not going to bend your case with the Dremel.

by **gvblake22** » Thu Jul 21, 2005 12:43 pm

infinitevalence wrote:Dremel is the way to go get the fiberglass reinforced cutting wheels. Tape off your design and take your time! but it works. If you have a decent jigsaw with a very good blade then its not so bad, but your not going to bend your case with the Dremel.

Awesome, thanks :mrgreen:

by **gvblake22** » Thu Jul 21, 2005 12:50 pm

HAHA, ok, one more Q...

Do you think it would be a bad idea to try and affix a thin plexiglass window to a side panel using some good double-sided tape? Screws are just so tedious and not as good looking and if you don't line up every single screw hole just right with the case and window the whole thing gets warped and it's a PITA (yes I speak from experience...)

by **infinitevalence** » Thu Jul 21, 2005 1:01 pm

yeah some decent 3M tape should work just fine, you might want to rough up the edges with some sand paper just to give it more to hold on to but thats all.

by **Apoptosis** » Thu Jul 21, 2005 1:35 pm

I tape what I am cutting and then use a dremel tool. It helps keep the paint from getting chiped as bad from my expierence.

by **gvblake22** » Thu Jul 21, 2005 2:01 pm

Apoptosis wrote:I tape what I am cutting and then use a dremel tool. It helps keep the paint from getting chiped as bad from my expierence.

Yeah, I always mask off where I am cutting, it definately helps. But I am referring to actually attaching a window to the side panel (or anywhere for that matter).

Thanks for your help Infinitevalence! :mrgreen:

by **infinitevalence** » Thu Jul 21, 2005 2:05 pm

never a problem

by **InFuZiOn** » Fri Jul 22, 2005 9:00 pm

I need to buy a dremel myself and then I can try to start modding a little.

Effectiveness of using a Dremel Tool to cut steel?

Effectiveness of using a Dremel Tool to cut steel?

Who is online