LED voltage?
LED voltage?
Hello, i was given some LED rail thingy's its got on LED that shines light into a solid plastic tube looks cool on the portable H/D but how many volts are they? i was wondering this because i want to mount them im my case, their sweet they flash different colours!
Main Rig: C2D 6850 @ 3.0Ghz, 2Gb DDR2667Mhz @ 833Mhz 5-5-5-15 Timings , XFX xXx 8600GTS @ 730/2260 , Gigabyte Ga-945GCM-S2L
JukeBox: Currently in an Upgrade but im too lazy to do it at the moment
I² keepin it real
JukeBox: Currently in an Upgrade but im too lazy to do it at the moment
I² keepin it real
- Dragon_Cooler
- Legit Extremist
- Posts: 2405
- Joined: Wed Oct 12, 2005 10:17 am
- Location: DFW Texas
- Contact:
Depending on the color will depend on the voltage, blue is usually a little higher around 3.2-3.4 volts.
If it is just one led you will need an inline 470ohm resistor.
This site is pretty helpful:
http://www.kpsec.freeuk.com/components/led.htm
just what ever you do dont hook the LED straight up without a resistor, if it doesnt already have one!!!
If it is just one led you will need an inline 470ohm resistor.
This site is pretty helpful:
http://www.kpsec.freeuk.com/components/led.htm
just what ever you do dont hook the LED straight up without a resistor, if it doesnt already have one!!!
- Dragon_Cooler
- Legit Extremist
- Posts: 2405
- Joined: Wed Oct 12, 2005 10:17 am
- Location: DFW Texas
- Contact:
If you run 2 LEDs without a resistor, you'll blow them because the current will be infinite since LEDs don't have an internal resistor.
LEDs need between 1.6V and 3.2V to run, depending on the color, but that's not really important since you'll be running on 12V.
Basically take your source voltage (12V) divide by 20mA (that's about the current a LED needs to produce decent lighting), so you'd need a 600 ohm (not sure if those exist, but I know for sure 680 exists and would work) resistor.
Also, I read you original post and the LED doesn't flash by itself, it's most likely controlled by a simple circuit.
LEDs need between 1.6V and 3.2V to run, depending on the color, but that's not really important since you'll be running on 12V.
Basically take your source voltage (12V) divide by 20mA (that's about the current a LED needs to produce decent lighting), so you'd need a 600 ohm (not sure if those exist, but I know for sure 680 exists and would work) resistor.
Also, I read you original post and the LED doesn't flash by itself, it's most likely controlled by a simple circuit.
- Dragon_Cooler
- Legit Extremist
- Posts: 2405
- Joined: Wed Oct 12, 2005 10:17 am
- Location: DFW Texas
- Contact: