I have a Gigabyte M61P-S3 board. I bought a Athlon 64 x2 6000, 3.1 GHz to replace my Athlon 3800. I did a BIOS update, swapped processors out, rebooted and I get no POST at all. Just fans. No beep code. nothing.
I put the Athlon 3800 back in and it works fine. My question... Is there something else that I have to do in BIOS so the new processor will boot or does it sound like a dead processor?
Another thing. I did try to use the processor before I did the BIOS update and it would boot but system would shutdown after a few minutes. Like I said, that was before. Now nothing but fans. Any thoughts on this?
BIOS update ?
Re: BIOS update ?
I am leaning toward a bad processor. Try reducing to the minimum on the computer, 1 stick of ram, processor, and gfx card and see if you get it to post. That would be my next step.
- Apoptosis
- Site Admin
- Posts: 33941
- Joined: Sun Oct 05, 2003 8:45 pm
- Location: St. Louis, Missouri
- Contact:
Re: BIOS update ?
Could be a bad processor or a BIOS update that doesn't play nice with that specific processor.
I know people used the F5 bios with a 6000+ a couple years back with some success. I guess you are running BIOS F7F? What BIOS did you update from where the 6000+ would shut down after a little bit? I vaguely remember that board... hard to believe that is circa 2007
I know people used the F5 bios with a 6000+ a couple years back with some success. I guess you are running BIOS F7F? What BIOS did you update from where the 6000+ would shut down after a little bit? I vaguely remember that board... hard to believe that is circa 2007
Re: BIOS update ?
Was using BIOS F2. That was what the board came with.
Re: BIOS update ?
Try clearing the CMOS. I have to clear the CMOS on my M2N-E everytime I update the BIOS.
Intel Core i5-3570K @ 4.2Ghz @ 1.16V (CPU-Z + LinX)
Gigabyte Z77X-UD5H F14 BIOS
ASUS GTX 460 768MB @ 800/1950
Kingston HyperX DDR3 8GB @ DDR-1333
Corsair AX750
Crucial M4 128GB
Western Digital Black 1TB
Cooler Master Hyper 212+ EVO
BenQ E2420HD
---------------------
I AM CANADIAN!
Gigabyte Z77X-UD5H F14 BIOS
ASUS GTX 460 768MB @ 800/1950
Kingston HyperX DDR3 8GB @ DDR-1333
Corsair AX750
Crucial M4 128GB
Western Digital Black 1TB
Cooler Master Hyper 212+ EVO
BenQ E2420HD
---------------------
I AM CANADIAN!
Re: BIOS update ?
Would that cause it to do nothing but fans? Also clear the CMOS could fix the problem I've posted? Sorry for the questions but I feel dumber than a nail right now.geokilla wrote:Try clearing the CMOS. I have to clear the CMOS on my M2N-E everytime I update the BIOS.
- Apoptosis
- Site Admin
- Posts: 33941
- Joined: Sun Oct 05, 2003 8:45 pm
- Location: St. Louis, Missouri
- Contact:
Re: BIOS update ?
Clear the CMOS and if that doesn't work I'd flash the board with BIOS F5 and try that... It's a good practice to always clear the CMOS after a BIOS flash and then load optimal defaults.mcleod55 wrote:Would that cause it to do nothing but fans? Also clear the CMOS could fix the problem I've posted? Sorry for the questions but I feel dumber than a nail right now.geokilla wrote:Try clearing the CMOS. I have to clear the CMOS on my M2N-E everytime I update the BIOS.