HI
I have the board for the last year and upto now i was using 2*80GB IDE drives.
I have just connected 2 250GB SATA 2 drives and wanted to work in RAID.
The problems:
1) The RAID BIOS (F10) is not showing unless i enable RAID on the IDE drives. (i have enabled IDE RAID ROM in the BIOS).
2) When i managed to config the RAID (STRIPING) i installed windows on the RAID and after installation finished the system start booting nonstop.
3) I cannot boot into the Current (IDE) windows when raid on SATA is enabled.
In Short my setup:
IDE 1 : MASTER 80GB HD
SLAVE 80GB HD
IDE 2 : MASTER DVD-RW
SLAVE NONE
SATA 1 - NONE
SATA 2 - NONE
SATA 3 - SATA 250GB
SATA 4 - SATA 250GB
RAID BIOS ENABLED
RAID enabled on SATA 3&4
Please advise.
-------------------------
CPU A64 [email protected]@1.38V
VGA XFX 7800GT @ Stock
MEM Geil Value 2*512MB DDR400 @ 200Mhz
MB Epox 9NPA+ Ultra - BIOS 4/18/06