Legit Reviews

Finally, some progress... this is what I found on the Razer support website... http://i96.photobucket.com/albums/l168/LON7WOL5/RazerBarracudaAC-1Pinout.jpg My P180 case has seven individual audio pins which are labelled as follows: Pin 1 - Microphone Signal Pin Pin 2 - Microphone Power Pin 3 - Groun...

Hello I have a very similar setup - Bad Axe 2, two 150GB Raptors in RAID 0 (Intel Matrix RAID Controller Channels 0 and 1) array and two non-RAID 500GB Caviars (Intel Matrix RAID Controller Channels 2 and 3). The problem is that when I select to install Windows on C:\ (the RAID 0) volume, Windows in...

I usually do RAID on the primary array and then after windows installs, I add the other pair of drives and set them up. I've honestly never tried doing four fresh drives and a windows install at once. If I understand correctly when I setup Windows I must remove the partitions on all three HDD's, an...

Hello I have four HDD's in my system - two 150GB WD Raptors and two 500GB WD Caviars. I successfully created a RAID 0 volume (Intel Matrix Controller) consisting of the two Raptors. When I proceeded to install Windows XP it correctly detected my the "three" drives on my system. I then part...

Hello

I trying to connect the Razer Barracuda AC-1 audio card to the front audio ports of my Antec P180 case. The case's connector does not fit so I'm trying to connect the individual wires but need the pinouts of the Razer card. Any help?

Thanks

Hello

How do I activate the ASUS Game Replay utility?

My card runs at 76ºC idle and up to 98ºC under load. I have an Antec P180 case. Removing the side panel decreases the temperatures considerably. Is there any after market cooler I can buy to cool my card down?

Thanks

Hello

My C: dirve consists of two 150GB Raptors running in a RAID 0 configuration via the Intel RAID controller (Channels 0 and 1).

I assume NCQ is enabled by default but how can I disable it?

Thanks