Legit Reviews

Count me in!

Regards,
Jerry

Well the problem is solved. All that I had to do was to shutdown the machine and pull the plug! When I rebooted the processor thermal margin was normal. Go figure.....

Regards,
Jerry

I have a QX6700 processor running on a BadAxe mombo and all of a sudden the BIOS thermal margin shows 0! I have installed the latest BIOS update and the problem still exists. It even shows 0 right after start up after sitting off overnight. This is new, the thermal margin had been acting normally up...

Problem solved! I opened my system up and connected the bare drive to the Marvell SATA port directly and found that I had to configure the drive as 150 MB/S to get the controller to recognize it. I have re-installed it into my eSATA enclosure and it works! Thanks for taking the time to help rwolds9....

I did install the drivers for Windows (F6 during Windows install). My thinking is that there is some problem with the controller since it does not find the drive during the POST. The Marvell BIOS comes up, but after a while it reports no drives found.

Regards,
Jerry

I am using the cable supplied with the external enclosure. The drive is not recognized by the Marvell controller during boot. Are you talking about Windows drivers, or something for the BIOS?

Regards,
Jerry

Hmmmm. When i press ctrl-m the Marvel controller does not recognize that there is a drive connected. Any idea why, or what I can do to get this to happen?

Regards,
Jerry

I have all of the Intel SATA ports in use, with 2 of them RAID 0. I would like to use a single external drive (NextStar 3 enclosure) using the internal connector supplied with the enclosure in the red Marvell e-sata port with no other drives on that controller. When I turn the drive on and boot the ...