I have G.Skill DDR500 RAM that I suspect to be acting up. During one of my overclocking ventures, I pushed the FSB to 260, then 270 without realizing the divider was set to 5/4, which pushed the RAM to an effective speed of over 600MHz! It held into BIOS, then crashed. I repeated this process, not knowing that the K8N Diamond Plus had defaulted to this setting. After about 15 minutes I realized and hoped I hadn't cooked my RAM. Memtest shows errors at overclocked speeds below the rated speed of DDR500 at 3-4-4-8.
Now I'm getting memory errors on exiting any 3D game, iTunes sits and plays but gets random memory errors as well, and my 3D modeling apps feel sluggish. Rebooting is no help. Think I should buy some of
this Corsair? I was looking at an OCZ kit but the site that had it for $229.00 with free shipping is out of it now...
Can't afford to wait for an RMA...
