You are correct, no strips!
Apparently they were included a few yrs ago, not anymore!
I have no idea what color but,
The iCUE software opens that up to a whole lot of options with the ARGB fans!
I may have to splurge a little and get some of the LED strips!?!
That will probably be decided when I figure out what case the new build will be in!
I finally got around to doing something I wanted today!
I moved the hardware out of my old case into the Chartreuse 900...as always it didnt go as planned!
Most of it was good, until I got to the point of installing the PSU.
I have a Corsair RM750x in the setup which didnt fit so well in the Antec 900!
The RM750x is about 2 inches longer than a standard PSU & fully modular and would've been a really tight fit!
The 900 does not do well with cable management to start and the larger PSU made it even worse!
My cable job is not that great in this case. Not even good!
So I decided to change things up! I pulled out the PSU(CX750F RGB) that was supposed to go in my new build and installed it in the 900! At this point it looks like the RM750x will go to the new build which creates another problem, ok, same problem, it doesnt fit in the case(Segotep Typhon which is a whole other story!) I have for the new build either!
At this point its up and running and no issues!
I need to order a 3pin fan ext. With 2 fans and pump on AIO water cooler,
I did not have a fan port close enough to the top 200mm fan!