Legit Reviews

Is there anything special in the setup for gpu3 on an sli system? gpu#2 keeps getting unstable machine. As soon as it loads the work unit it instantly fails...so i'm pretty sure something is goofy with the set up. I have windows 7 64 bit I7 yada yada and 2 GTX 275s. I did what the folding@home page said to do.. http://folding.stanford.edu/English/WinGPUGuide . Have the newest driver installed, sli enabled.

Project: 6604 (Run 2, Clone 392, Gen 659)
[00:19:50]
[00:19:50] Assembly optimizations on if available.
[00:19:50] Entering M.D.
[00:19:56] Tpr hash work/wudata_02.tpr: 870289678 491377154 3250926775 937840751 2180268824
[00:19:56]
[00:19:56] Calling fah_main args: 14 usage=100
[00:19:56]
[00:19:56] mdrun_gpu returned
[00:19:56] Going to send back what have done -- stepsTotalG=0
[00:19:56] Work fraction=0.0000 steps=0.
[00:20:00] logfile size=4947 infoLength=4947 edr=0 trr=25
[00:20:00] + Opened results file
[00:20:00] - Writing 5485 bytes of core data to disk...
[00:20:00] Done: 4973 -> 1847 (compressed to 37.1 percent)
[00:20:00] ... Done.
[00:20:00] DeleteFrameFiles: successfully deleted file=work/wudata_02.ckp
[00:20:00]
[00:20:00] Folding@home Core Shutdown: UNSTABLE_MACHINE
[00:20:04] CoreStatus = 7A (122)
Been a while sinse I did this stuff...so I might be doing something stupid

Nevermind...figured it out myself.

wi-fuzzy wrote:Nevermind...figured it out myself.

read my guide to SLI setups?

I'ld tell you what I did wrong....but you'ld still be laughing next week