Page 1 of 1
Folding questions
Posted: Wed Dec 07, 2005 6:23 pm
by FZ1
What is the right way to fold a shirt?
Kidding. If I am in the middle of folding and I geta BSOD, do I start over and get 0 credit for my work? I ask becasue my PC was working all night on a rather large one and it's BS'd on me near the end of it.
Second question, it appears that is it working both cores of my Opty 175 so is there any need to run dual instances (is it even possible)?
Posted: Wed Dec 07, 2005 6:47 pm
by infinitevalence
If it BSOD's then it submits what you have done and starts a new one. Its best if your system is stable before folding because if the data is no good, it kinda defets the purpose. Yes you have to have 2 instaces to fully use your dual core, this is done by making 2 folders and runing the setup twice, under machine number you put 1 for cpu1 and 2 for cpu2
Posted: Wed Dec 07, 2005 7:44 pm
by bigblockmatt
Posted: Thu Dec 08, 2005 4:38 pm
by FZ1
infinitevalence wrote:If it BSOD's then it submits what you have done and starts a new one. Its best if your system is stable before folding because if the data is no good, it kinda defets the purpose. Yes you have to have 2 instaces to fully use your dual core, this is done by making 2 folders and runing the setup twice, under machine number you put 1 for cpu1 and 2 for cpu2
The system is stable...user error
Peaking of user error...maybe I'm dense today but I tried installing another instance in a separate folder but I didn't see in the set up where I could specify a machine #?
Posted: Thu Dec 08, 2005 5:36 pm
by infinitevalence
its in the config file. open that up in notepad and edit.
Posted: Thu Dec 08, 2005 6:07 pm
by Illuminati
you have to say 'yes' to editing advanced options.
Posted: Sat Dec 10, 2005 1:53 pm
by FZ1
Well, no matter what I do I can't run 2 instances (always tells me there is another running.
I did the following:
>Installed into directory 1
>Installed into directory 2
>Ran #1 with "-local -config" and set configuration (there is no option for mach #). Made sure config file said machine 1
>Ran #2 with "-local -config" and set configuration (again no option for mach #). Edited config file to machine 2
Get error. Rinse and repeat.
Posted: Sat Dec 10, 2005 3:40 pm
by Dragon_Cooler
what the hell did she just do?!?!?!??!? dem chinese to quick!! lollolol
Posted: Sat Dec 10, 2005 4:23 pm
by kenc51
Are you using the console version?
I use the console version, when i run it in dos it asks for machine # & if i want to run it as a service!
I choose yes, and also run the standard version, that way i can r-click the taskbar and close 1 instance, but still have 1 always running in the backround.
Posted: Sat Dec 10, 2005 7:12 pm
by FZ1
I tried both versions.
