Water cooling my SF201K Case?

Skippman · Post by **Skippman** » Fri Apr 13, 2007 12:24 pm

Did you fab these yourself, or were these left over parts?

Bio-Hazard · Post by **Bio-Hazard** » Fri Apr 13, 2007 5:41 pm

A guy O know started making them, they were cut on a laser cutter and bent on a CnC bender, then welded and powder coated. I'm not sure if the guy is even messing with water cooling anymore as I haven't seen him around in a long time, but they were some nice shrouds.

Skippman · Post by **Skippman** » Fri Apr 13, 2007 7:57 pm

Check out what Koolance is selling now.

This might make it work.

Bio-Hazard · Post by **Bio-Hazard** » Fri Apr 13, 2007 10:16 pm

Koolance does have some pretty slick stuff as I said before, high quality and nicely finished products...........

Skippman · Post by **Skippman** » Sat Apr 14, 2007 4:47 am

I hope that gives me enough clearance. I'm going to take some measurements. They say you can use two if you need to futher increase the height but I'm concerned about the beveling on the shroud. It doesn't look like it stacks.