Page 1 of 1

Ataching Fan to CPU Heatsink

Posted: Fri Apr 11, 2008 3:50 pm
by whitey12785
Do I want my fan to blow on my heatsink or blow away from my heatsink to pull heat off?

also there are two arrows on the side of the fan. One pointing up and one pointing away from the fan in the direction of air flow. Does the Arrow indicate which way the air blows?

Should the side that the Heat sensor is on be up against the heatsink or on the side of the fan facing outwards?

Thanks for any help.

Re: Ataching Fan to CPU Heatsink

Posted: Fri Apr 11, 2008 5:05 pm
by DMB2000uk
It would help if we knew what the Heatsink was, to get a better idea of how it is going to be oriented, and if you have a case vent/fan at the back of your case.

Generally it is accepted to have the fan furthest inside your case pushing air through the heatsink towards the back of the case (preferably an exhaust). You can tell which direction the air goes with a fan, as they always move air towards the part of the fan with the X struts going towards the motor. So find the X, air comes out that side :P

If your heat sensor is a 'free standing' case thermometer type thing, then have it in front of the fan (so you can tell what the temperature of the air being used to cool the CPU is).

A bad ascii representation of the setup would be:
_______________________________
|........PSU......... |
|______________|
|
[Exhaust ] << ( Heat )[ CPU ] << Thermal
[ __Fan_] << ( Sink ) [ Fan ] << Probe
|


With "<<" being the direction of air :P

Dan

Re: Ataching Fan to CPU Heatsink

Posted: Fri Apr 11, 2008 6:16 pm
by whitey12785
haha well its a little trickier then that. This is my heatsink: http://deadeyedata.com/index.php?main_p ... rrency=USD

The "top view" picture listed here is what I want to focus on for a moment.

Looking at this picture exactly is a good representation of how it will look installed. The left of the picture is where the back cpu fans would be. (in fact I will most likely have to remove one of my two 120mm back fans to fit this heatsink) and to the right would be my cd/dvd drives and the front of the computer.

in the "3/4 view" of my heatsink you can see the holes that the screws go through to mount my two 60mm fans.

The fans are either going to blow down at the bottom of my case or up (through the heatsink) at the PSU.

other than the two rear fans I have a third fan in the middle of the side panel. Here is a link to my case.
http://www.newegg.com/Product/Product.a ... 6811156135

I hope this was enough information :) Thanks for your help bro.

Image

Re: Ataching Fan to CPU Heatsink

Posted: Fri Apr 11, 2008 7:54 pm
by stev
You have two choices for direction of the fan.

Match the fans to blow in the same direction as the PSU fan above it.

1. If the PSU fan is drawing air in to itself, then have your CPU heat-sink fans blowing up to the PSU.

2. If the PSU fans are blowing air into the case, then have the fans blow down. If the fans are blowing down, you will need a side panel fan to release the hot air from the case.

In my computer case, the PSU is drawing air out of the case to the back of the case and out. This follows both the Intel and AMD ATX thermal footprint.

Re: Ataching Fan to CPU Heatsink

Posted: Fri Apr 11, 2008 8:26 pm
by whitey12785
well that isn't a direct picture just an example, my PSU has no fan. But you guys have definately educated me enough to decide for myself what is the best set up.

Thanks for your insight and time.

Re: Ataching Fan to CPU Heatsink

Posted: Fri Apr 11, 2008 10:10 pm
by skier
is that PSU a coolmax AP450? looks verry familiar, and the 120mm fan does blow it out of the case, just not directly