Page 1 of 1
830 stacker and v1 cooler? will it fit?
Posted: Fri May 02, 2008 8:39 pm
by vidiotking
can anyone tell me if a thermaltake v1 cpu cooler will fit inside a coolmaster 830 case? i have read that some larger coolers will not fit w/o takeing the coolmaster case side fan panel out? any insites?
thanks in advance
Re: 830 stacker and v1 cooler? will it fit?
Posted: Mon May 05, 2008 4:57 pm
by Digerati
I'm not a 100% sure, as I have never seen that specific cooler installed, but a TRUE 120 will need the side fans to be gone if you install it, so I assume this one is the same.
Re: 830 stacker and v1 cooler? will it fit?
Posted: Mon May 05, 2008 8:38 pm
by vidiotking
i appreciate your response. but i am unsure wut u mean by a 'true 120'? cud u clarify? thanks.
Re: 830 stacker and v1 cooler? will it fit?
Posted: Tue May 06, 2008 5:56 pm
by Digerati
vidiotking wrote:i appreciate your response. but i am unsure wut u mean by a 'true 120'? cud u clarify? thanks.
Thermalright Ultra-120 Extreme, commonly referred to as TRUE 120.
Re: 830 stacker and v1 cooler? will it fit?
Posted: Tue May 06, 2008 6:47 pm
by vidiotking
so you're saying these two coolers have about the same hight. thanks! guess ill use another cooler.
Re: 830 stacker and v1 cooler? will it fit?
Posted: Wed May 07, 2008 8:58 am
by DMB2000uk
The V1 is actually about 23mm smaller than the TRUE.
The manufacturers specs list the height of the V1 at 143mm.
So if you have a tape measure and the case already, you can measure it out.
Dan
Re: 830 stacker and v1 cooler? will it fit?
Posted: Sat May 17, 2008 7:11 pm
by HôS
I have the CoolerMaster Stacker 830 with a Zalman CNPS9500A LED CPU fan installed on my motherboard .
Dimensions are listed at 85mm L x 112mm W x 125mm H . The actual fan is 92mm in diameter and 25mm in depth .
I would highly recommend this fan for this case and any compatible motherboard .
It fits nicely inside the case with fan panel in place and all 4 side panel fans installed .
It's quiet and extremely effective .