Legit Reviews

I'm having trouble finding a direct comparison of these two blocks, anyone have a link?

Little River Storm G4 that is

I didn't even know Cathar was producing blocks again....good to know, his stuff is top notch. To be really honest, you can't go wrong with either block, both are great water block manufacturers...i honestly doubt you would see much, if any difference between the two.

I'm not sure if he was or wasn't just heard those were the two best. Guess I"ll go with the PolarFlo since its very easy to get.

You could also look at the D-Tec Whitewater i think he did the desine for that block as well.

Joe Camel wrote:got my E-Mail from Cathar today with the good news...Pre-Orders are starting!!!

so check your "in boxes" people the wait is over!!

Looks like he might be at it again

http://www.ocforums.com/showthread.php?t=369064

bah the polarflo is all about bling (peformance is about the same as a maze4), you would be far better off getting a mcw6002 (1/2") or mcw6000 (3/8") for about $40 which would definetely outpeform it. i know some people at procooling have questioned their anodizing quality as well (even with that it will still corrode). if you dont want to wait for cathar's http://www.procooling.com/html/pro_testing.php can help you decide what one works best with your flow rate

I hate to dig up a old thread, but I just had to start something. Ive been running the PolarFlo blocks for some time now with no problems (both the original and TT blocks, I have both types). I also have the Swiftech MCW 6002 and I've gotten better temps with the PolarFlo block in either the 2 or 3 barb configuration.................. I don't have a lot of faith in charts and formulas and all that other crap, real world is what I'm talking about.

And now to the main reason for this post............ PolarFlo has released they new water blocks using a Acrylic Top for all of you that were worried about using aluminum in your systems.

http://www.polarflo.com/index.asp?PageA ... D=120&HS=1

Xerxes wrote:bah the polarflo is all about bling (peformance is about the same as a maze4), you would be far better off getting a mcw6002 (1/2") or mcw6000 (3/8") for about $40 which would definetely outpeform it. i know some people at procooling have questioned their anodizing quality as well (even with that it will still corrode). if you dont want to wait for cathar's http://www.procooling.com/html/pro_testing.php can help you decide what one works best with your flow rate

Both the water blocks you mentioned are great ! top of the line.

I am going to use the Innvotek V6 with lighsts its not as good as what your looking at. But I well be using chiller so I am going for looks and besides the Yonah and Conroe CPU'S run cool anyway. See it here!

http://www.highspeedpc.com/Merchant2/me ... nnovatekV6