Page 1 of 1
600W OCZ Powerstream Question
Posted: Sun Dec 25, 2005 3:28 pm
by Apoptosis
I'm working on an Intel article and noticed my 3.3V rail is under so I incresed the voltage on the OCZ 600W Powerstream PSU. The voltage rail LED goes from green to red and the system shuts down... Anyone have this happen to them?
Posted: Sun Dec 25, 2005 3:42 pm
by kenc51
nope.....I had/have my 3v line @ 3.5v on the SLI-DR with big-toe's vdimm mod.....I'm now using the expert board...but still with the 3v line @3.5 (in the red)
Could it be your multimeter?
Posted: Sun Dec 25, 2005 10:08 pm
by infinitevalence
Have you treid using a DMM to check the voltage? it could just be the sensor on the motherboard.
Posted: Sun Dec 25, 2005 10:55 pm
by Apoptosis
I loaned out my volt meter so I am in the dark this weekend... oh well I gave up on it.