Page 1 of 1
Lapping Zalman
Posted: Sun Aug 15, 2004 10:42 pm
by BoxsterS258
I have decided to lap my zalman 7000A CU cooler, but if you own one you know that you cant set it down on sandpaper because there are 2 ridges that keep the flat area of the heatsink from touching the level sandpaper. How would you go about doing this?
Posted: Tue Aug 17, 2004 2:15 pm
by BoxsterS258
anyone?
Posted: Tue Aug 17, 2004 2:24 pm
by infinitevalence
The best suggestion i can think of is to use a peice of glass that fits between the ridges. Then lap in one direction. it may not be posible to lap that sink with out grinding off the ridges.