okay so i was talking on the phone and overclocking (there should be a PSA about not doing that ) and i set my frequency a *tad* too aggressive and i'm not posting. my motherboard is listed in my sig, and i'm just double checking the prodedure to reset it.
1. turn off PSU, unplug from wall
2. remove CMOS battery for a few seconds
3. reinstall battery, plug in, turn on
should that take care of it? i'm angry at my manual cause it has EVERYthing about bios stuff EXCEPT how to reset....
thanks guys!
Cyberpower generic case
B450M PRO-VDH MAX
Ryzen 5 3600 w/PBO/OC
CM Hyper 212 EVO push/pull
Corsair VENGEANCE LPX 16GB (2 x 8GB) DDR4-3600 CL16
MSI RTX 3060 Ti Ventus 3X 8G OC LHR
Samsung 970 EVO Plus 500GB
6GB Seagate HDD
EVGA 650BQ 650W PSU
ASUS VE278 27" monitor, Dell E2216HV (vertical)
Logitech Z533 2.1 Speakers, G935 7.1 or G435 headset
MS LXM-00001 keyboard
Razer Deathadder Elite, XBOX One Lunar Shift controller
I've come a long way from my original Core2Duo E6750 build y'all!
Power up as normal, then just before you would expect the bios screen to display, power off again via the PSU switch, or unplug if you have to.
The bios will detect the failed boot and when you start again, it will boot with default settings.
You will get a message "Overclocking failed, press F1 to enter BIOS, or F2 to continue"
Press F1, to get back into the bios and just change the last setting back to where it was ;)
1. turn off and unplug
2. at CLRTC jumper (near bios chip, low right) move from pins 1-2 (default) to pins 2-3
3. plug in, turn on
4. hold DEL key during the boot process, enter BIOS setup re-enter data.
edit: Ken was faster LOL
"The democracy will cease to exist when you take away from those who are willing to work and give to those who would not."
-Thomas Jefferson
) and i set my frequency a *tad* too aggressive and i'm not posting. my motherboard is listed in my sig, and i'm just double checking the prodedure to reset it.
