Hi All,
I recentaly purchage intel D945GCL + intel c2d 2.4Ghz.The Problem is,it dosent detect third IDE.It works fine with a hard disk and a DVD Writer or Two HDD.When I connect all three,Either it dosent boot or few vertical lines appears on the screen.
Plz somone help me.
no detecation of third ide peripheral
-
- Legit Little One
- Posts: 2
- Joined: Wed Jun 18, 2008 10:20 pm
Re: no detecation of third ide peripheral
sounds like the mainboard isn't working right
might want to send that back and get a new one
that would be my guess
might want to send that back and get a new one
that would be my guess
- martini161
- Mr Awesome
- Posts: 3183
- Joined: Sat Sep 08, 2007 8:27 pm
- Location: Cherry Hill, New Jersey
Re: no detecation of third ide peripheral
do you have them all connected with one ide cable? or is it a 2 hard drives on one, a dvd on the other?>
Dan:3Martin:3 "my manhood is so big if i put it on the keyboard it would stretch from A to Z!"-Anonymous
Re: no detecation of third ide peripheral
How are you connecting 3 IDE devices?
The board only has one parallel port, and one parallel cable can only support 2 IDE devices.
Dan
The board only has one parallel port, and one parallel cable can only support 2 IDE devices.
Dan
-
- Legit Little One
- Posts: 2
- Joined: Wed Jun 18, 2008 10:20 pm
Re: no detecation of third ide peripheral
Currantly I am using 2 sata hard drives and a SATA DVD Writer.My MOBO Supports 4 SATA & 2 PATA peripharals.kamalkhandal wrote:Hi All,
I recentaly purchage intel D945GCL + intel c2d 2.4Ghz.The Problem is,it dosent detect third IDE.It works fine with a hard disk and a DVD Writer or Two HDD.When I connect all three,Either it dosent boot or few vertical lines appears on the screen.
Plz somone help me.
All was ok when I was using 3Ghz Dual Core Processor with this board.Is it possible that 2.4 Core 2 Duo is causing problems?
Re: no detecation of third ide peripheral
So, you're mixing a few IDE drives and SATA drives on this board eh? That's always something to cause the MOBO a little confusion. Does your manual state how many IDE+SATA devices can work at the same time?
My heatware!
Support Your Local Sheriff - At high noon
Jason: "How much does it pay?"
Citizen: "Well, none of our other sheriffs ever lived long enough to find out."
Support Your Local Sheriff - At high noon
Jason: "How much does it pay?"
Citizen: "Well, none of our other sheriffs ever lived long enough to find out."
Re: no detecation of third ide peripheral
That shouldn't be a problem. SATA and IDE can coexist peacefully . IDE is usually considered the first set of masters, depending on how many IDEs there are.bmaverick wrote:So, you're mixing a few IDE drives and SATA drives on this board eh? That's always something to cause the MOBO a little confusion. Does your manual state how many IDE+SATA devices can work at the same time?
Speaking of masters, I would check each one to see if they work properly. And reset cmos too. But when it comes all down to it, unless there's a bios update, I'm going with the first reply: RMA the board.
-- top