Page 1 of 1
Intel DX58SO 'Smackover' Motherboard Has A Tight Fit
Posted: Fri Jan 15, 2010 11:26 pm
by gregerson
I just bought a smackover and a Theralright 120 extreme with the bracket system that has a single bar going across the middle. It is a very tight fit near a number of components on the MB and I'm a little nervous. Any one had particular luck with on of the new mounts?
Thanks.
Re: Intel DX58SO 'Smackover' Motherboard Has A Tight Fit
Posted: Sat Jan 16, 2010 11:15 am
by dicecca112
You're more likely to get an answer to your question if you post a new thread, not in an existing thread that was 3 years old. I've split it off from that thread and created a new one.
Welcome to the forums, and good lucky getting your question answered
Re: Intel DX58SO 'Smackover' Motherboard Has A Tight Fit
Posted: Sat Jan 16, 2010 11:36 am
by bubba
Yup it fits. I've had it on the test system for LR, which has the DX58SO and an i7-920.
Don't have a shot of it with me, but here is a shot of the COGAGE True Spirit installed. It uses the same mounting system as the Thermalright 120/Ultra 120/TRUE/TRUE Black/TRUE Copper/Ultra 120 eXtreme 1366RT
http://www.legitreviews.com/article/1108/3/
