Page 1 of 1
X1950 XTX CROSSFIRE WITH THE D975 XBX2
Posted: Sat Mar 24, 2007 10:40 pm
by stevethetileguy
does anyone else have artifact problems running crossfire (2 x x1950 xtx) with catalyst a.i enabled , when i disable it its fine ! im running the 2507 bios , ive tried the new catalyst (7.2) and all versions before
Posted: Sun Mar 25, 2007 2:59 am
by IRQ Conflict
Try enabling vsync?
Posted: Sun Mar 25, 2007 6:33 am
by Apoptosis
I've run this configuration and didn't have artifacts when I did. We also ran all of the ATI graphics cads on the D975XBX2 motherboard in this article and Bad Axe 2 handled all of the cards in this article without issues:
http://www.legitreviews.com/article/474/1/
Posted: Sun Mar 25, 2007 9:36 am
by IRQ Conflict
Steve, do you use driver cleaner when testing various driver/CCC versions?
Link
Posted: Sun Mar 25, 2007 1:26 pm
by stevethetileguy
yes vstnc is on and yes i use drivercleaner , Apoptosis what bios are u running ?, its strange sometimes it does it right away then sometimes it takes 2-5 minutes
Posted: Sun Mar 25, 2007 1:40 pm
by stevethetileguy
hi Apoptosis how did u set up the ccc control panel i like to have all the settings maxed ! (14x aa , 16 x as )or should i let the aplication decide ? and did u trie x1950 crossfire with bf 2142 is there a bios option im missing ? for pci-e ?