I'm not sure if any of you all follow water cooling much, but Swiftech has updated their complete top performing kits. I comes complete to cool the CPU, GPU and chip set. There are even ram sinks for the video ram.
Manufacturer Suggested Retail Pricing; $349.95
For those of you looking to cool only the CPU and need a new CPU block, Swiftech has also released a up-dated Storm block (rev 2) that has increased flow and less pressure drop which should also help if you decide to mate it with a GPU block.
I totally missed the release of the Storm update.............. And I was just checking out Swiftechs site for other stuff I might want cause I just finished thie new GPU block and just happend to look through their new releases.
Very cool. I have a swiftech kit in mym main rig and have been thinking about going the water route in my backup as well. Might as well spend some more $
You won't find a better performing kit around IMHO. As for the chipset block, I think they are a waste of time though. What you get out of water cooling the chip set isn't worth the added heat and restriction the chipset blocks adds to the cooling loop. But the options are there for those that want to add it.
Bio-Hazard wrote:You won't find a better performing kit around IMHO. As for the chipset block, I think they are a waste of time though. What you get out of water cooling the chip set isn't worth the added heat and restriction the chipset blocks adds to the cooling loop. But the options are there for those that want to add it.
I'm with you on that. I replaced my DFI POS shipset fan with an evercool vc-re and it never hits 40.
I don't think Swiftech's chips cooler will fit on a Lanparty board either......
I'm going to watercool my chipset for 1 reason........I hate the noise....
I've yet to come accross a chipset fan that doesn't make a whining noise after a few months......my chipset makes more noise than my PSU
I'm still running my stock fan on my chipset and it's quiet (I keep the speeds turned down manually) and the temps stay under 40c, but I've got 2 120 fans on my radiator blowing across my MoBo, so things stay very cool.
I use a single 120mm fan for intake (1000rpm)
My chipset runs @ 50-53C and the fan revs up to ~5000rpm
It was the same with my sli-dr
My 4 HDD's still stay under 40C - PWMIC never goes over 45C and the rest is/will be watercooled......
I agree watercooling your chipset is not required by most........unless you want very low noise and are prepared to pay for quality h2o cooling components.
I know a few people that have some super silent PC's and have water cooled everything and it works very well for them. I've seen a few folks water cooling their ram, PWMIC, HD's, I figure that they must have as much tied up in water cooling as they do in their computer. But if you have the cash and silence is what you're after, then go for it as they say.............
with my P4 rig, when it was watercooled I couldn't tell if it was on.....I could wake up @ 4am and could only tell it was on by the power light
I can'tget that back anymore as my current PSU is too noisy.....but I'm trying LOL
watercooling the ram and pwmic is a bit overboard......imaging each waterblock costs ~$50 --> chipset - cpu - ram - gfx - pwmic and maby even more......$$$$$$$$$$$$
I will say that my swiftech pump is the loudest thing in my system. I don't sleep in there though and typically I have music going loud enough to wake the dead so no biggie.
And I was just checking out Swiftechs site for other stuff I might want cause I just finished thie new GPU block and just happend to look through their new releases.
We need somemore water converts............... 
