ARRRGGGHHH! Raptors! Paging Errors! WHY?

Sovereign · Post by **Sovereign** » Mon Jun 19, 2006 9:26 pm

I had a Raptor 150 die on me, and now have a replacement. It was working fine, until today (6/19) at about 3:54PM. I get a large number (10-20) of this error in the Event Log:
An error was detected on device \Device\Harddisk0\D during a paging operation.

For more information, see Help and Support Center at http://go.microsoft.com/fwlink/events.asp.
This is the same thing that showed up in my OLD Raptor 150 before it died. WHAT THE HELL IS GOING ON????????

Pengwin · Post by **Pengwin** » Mon Jun 19, 2006 11:01 pm

wait...this is the Western Digital Raptor?!!?!!?!

i thought those were good HDD.

hmm....i guess im entitled ot say shoulda gotten a Seagate Cheeta.

Post by **DMB2000uk** » Tue Jun 20, 2006 5:54 am

Are you running any sort of RAID?

Dan

Sovereign · Post by **Sovereign** » Tue Jun 20, 2006 8:59 am

RAID is on the 2x250GB Caviars. Thing is, when my first Raptor died, I ran the Caviars RAID0 hooked to the very same nF4 controller wiht NO ISSUES EVER. I moved the Raptor's SATA port around, and now the issue seems to be intermittent, although my boot time is significantly longer than it used to be....

Sovereign · Post by **Sovereign** » Tue Jun 20, 2006 4:25 pm

I figured out what was wrong with my Raptor. Native Command Queing was on. It was corrupting my data. It got so bad that I had to install the recovery console and CHKDSK /R from there. Now those stupid Event ID 51s (error detected during a paging operation) are gone, and boot time is lower!

I bet my old Raptor 150 wasn't bad, just corrupted from NCQ crap....I HATE THAT NCQ THING.

Post by **DMB2000uk** » Tue Jun 20, 2006 5:20 pm

Glad you was able to sort it out!

Shame i was too slow to post back to help you

Dan